Arduino Protoshield PCB [Design]

Description

You can select the board option to view each board main image.

OFPS-R3:

• Design based on arduino official protypeshield, but this is PCB only.
• Each purchse is for one board only, not include any other accessories.

OF-R3:

• Design based on arduino official rev3 board
• On board two LEDs place, not yet connected.
• Standard SOIC024 footprint for SMD IC
• Each purchse is for one board only, not include any other accessories.

OF-R3-2.0:

• Based on OF-R3 board, replaced with 12×11 2.0mm pitch pin holes
• Added more 2.54mm pin holes. Smaller size of SOIC foot print, and shorten singal line of IOREF.
• Mixed with 2.54 stanadard pin header, make the connection for 2.0 pitch board like wireless board more easy.
• Each purchse is for one board only, not include any other accessories.

H-Board

• PCB full covered with 2.54mm pin holes.
• Still stackable as an arduino prototype shield.
• Each purchse is for one board only, not include any other accessories.

FR-R1:

• Arduino classical prototype shield PCB board.
• A IC pattern for adding DIP ICs up to 20 pins
• Power rails down the middle and sides
• A reset button and an extra general use button
• 2 3mm general use LEDs, red and green, as well as 2 matching resistors
• The ICSP header is up top if you like to upload to your Arduino using a programmer
• A surface-mount chip area for up to 14 SOIC size parts
• Compatible with either tiny breadboards or ‘standard’ breadboards with the rails removed.
• Every pin is brought out, including the new 3V and Reset header pins
• 2 0.1uF capacitors on either side for extra power stability

Other parts which are needed for these PCBs:

• Break away pin header male
• Arduino special pin header
• 3mm dia. LEDs and 1K resistors.
• Buttons
• Decouple capacitor 0.1UF

Documentation:

• Schematic available on this page.

Additional information