- Description
- Additional information
- Reviews (10)
- Enquiry2
Description
Simply the interface of 1602 to IIC, save more IOs, with this board you only need two IOs.
This board is also supporting 2004A which is also available in our store.
Product info:
- Supply voltage: 2.5-6V
- 41.5mm (length) * 19mm (W) * 15.3mm (height)
- IIC I2C Interface.
- Contrast back light can be adjusted by rotating the blue potentiometer, clockwise to increase, counterclockwise weakened. Potentiometer design on the front, enabling customers to freely adjust anytime
- 4-wire output
- Modules can be cascaded up to cascade 8. By short-circuiting A0/A1/A2 modify the device address. The default address is 0x27
- With backlight power control, can be connected via jumper settings are backlight power. Plug the jumper to connect the backlight off, unplug the jumper to disconnect the backlight power
Documentation:
Additional information
| Weight | 0.01 kg |
|---|
maykel (verified owner) –
recently bought 2 off these.
one for a new lcd also comming from here.
and the lcd that came with the ardunio starterpack.
and its working very good easy to solder and program.
no bad points what so all.
realy good solution to keep pins availible
Sachin (verified owner) –
Nice product, saves IO lines on your MCU!
yfands (verified owner) –
I needed all my IO lines and there was no room for a display to connect. This board was the answer via the I2C interface I was able to complete my project. You can solder the pcb on the back of the LCD Display through the connection pins.
an alternative library for Arduino can be found here:
https://bitbucket.org/fmalpartida/new-liquidcrystal/wiki/Home
(don’t forget to use the right I2C address)
miro (verified owner) –
The I2C address of the unit I received is 0 x27, Everything works as it should,
chapuzzo (verified owner) –
Awesome quality, frees a lot of pins in my gadget
Serafim –
Good module.
Be sure to power it with 5V, with 3.3 it will not work.
Jacques (verified owner) –
This is vey nice to use with a 1602 LCD display, as it allows to use it with only two pins (plus vcc and GND) .
thiagoas (verified owner) –
Works great, very useful to free some pins on the microprocessor.
muunokhoi (verified owner) –
Works great with the 1602 and 2004 displays.
vestale (verified owner) –
Works great, very useful to free some pins on my Arduino.